Back To Main Project Vehicles Page Axle Conversion System - housings and axle gears Our axle conversion system requires the old bearing race to be cut off of the axle housing and the housing end bored for an axle seal and axle clearance. The old stock axle system relyed on a press fit of the hub onto the axle. Under some load conditions, the axle can fail. The above picture showes an axle that twisted. Our new axle gears are designed to accept modern style 28 spline axles. The above pictures show an original axle next to a modern axle with our axle gear. Back To Main Project Vehicles Page Our location: 1818 W. Orchard Ave., Nampa, ID 83651 © 2006 Copyright, The Hot Rod Works, Inc. All Rights Reserved. Web Design by Websonic